化工事故应急救援仿真演练系统的实施探讨

阐述了化工事故应急救援仿真的必要性及其国内外研究进展;提出整个系统的框架并设计系统开发过程的模型;分析了基于高层体系结构(HIA)的仿真系统的开发要点,给出参考开发工具,从而为整个系统开发提供思路.     

层次分析法的改进及在安全决策中应用的研究

本文根据化工行业的特点及调研资料，建立了影响安全的层次结构模型即安全指标体系。并利用改进式层次分析法（IAHP）对该体系进行分析，得出了各个因素对安全的影响系数（权重）。     

载钯螯合树脂的制备、表征及其降解多溴联苯醚的初步研究

以聚丙烯醛-异烟酰腙螯合树脂为高分子载体, 利用其活性基团对钯的选择性富集分离性能, 将金属元素钯键合到高分子载体上, 制备一种含钯树脂材料(树脂1), 并进一步原位还原得到还原态的载钯树脂(树脂2)。利用红外光谱、扫描电镜和X射线衍射等对以上2种含钯树脂材料进行了分析表征，并考察了它们对持久性有机污染物(POPs)多溴联苯醚(PBDEs)的脱溴降解性能。结果表明,2种树脂对BDE₂₀₉均有降解活性， 其中树脂1的降解性能比树脂2的降解性能要高， 树脂中钯的氧化形态可能对BDE₂₀₉的催化降解起主要作用。     

O3-H2O2氧化法处理印染废水

采用O₃-H₂O₂氧化法对印染废水进行氧化处理，比较了O₃氧化法和O₃-H₂O₂氧化法对印染废水的处理效果，考察了初始废水pH、H₂O₂加入量、O₃流量和反应时间对废水的色度去除率和COD去除率的影响。实验结果表明：O₃-H₂O₂氧化法对废水的COD和色度的去除效果比O₃氧化法更好；在初始废水pH为11、H₂O₂加入量为13mmol/L、O₃流量为6g/h、反应时间为60min的最佳工艺条件下，处理后废水COD为61.50mg/L，COD去除率为95.73%，废水色度为5倍，色度去除率为99.75%，TOC为37.84mg/L，TOC去除率为85.10%，BOD₅为22.76mg/L，BOD₅去除率为90.20%，BOD₅/COD为0.37。     

城乡交错带土地利用方式对土壤理化性质的影响

以长沙市南郊山地丘陵区为研究对象，选择7种不同土地利用方式（次生林地、经济林地、杉木人工林、采伐迹地、撂荒地、苗圃地、坡耕地）研究了城乡交错带不同土地利用方式对土壤理化性质的影响。结果表明：7种土地利用方式下，土壤颗粒组成主要集中在1～0.05 mm和＜0.001 mm两个粒级范围内，土壤质地以重壤土和轻粘土为主。随着人为干扰程度的减弱，土壤砂粒（1.0～0.05 mm）、土壤粉粒（0.05～0.01 mm）百分率逐渐下降，＜0.01 mm的土壤物理性粘粒百分率增加。自然、半自然状态利用方式的林地（次生林地、经济林地、杉木人工林地）土壤总孔隙度、含水量普遍较高，土壤密度低于坡耕地、苗圃地、撂荒地、采伐迹地，而土壤pH值、有机质含量及氮、磷、钾含量普遍高于坡耕地、苗圃地、撂荒地、采伐迹地     

棉秆基活性炭的制备及其对2,4-二硝基苯酚的吸附

以棉秆为原料，以KOH为活化剂，制备了高比表面棉秆基生物质活性炭。分析了制得的活性炭的元素组成、表面官能团、吸附能力等物化性能，探讨了浸渍比，活化温度，活化时间等工艺参数对制备活性炭得率、表面官能团、碘值、亚甲基蓝值等性能的影响，并通过静态吸附实验比较了不同条件下制备活性炭对2，4-二硝基苯酚的吸附性能，探讨了典型炭样品对2，4-二硝基苯酚的等温吸附特性。结果表明，KOH活化棉秆基生物质活性炭的表面物化性质随浸渍比、活化温度等工艺参数变化而变化，活化适宜条件为浸渍比1：3、活化温度800℃、活化时间90 min，在此条件下制得的炭样的碘值为1 251 mg/g，亚甲基蓝吸附值为478 mg/g，分别是国家一级品标准的1.25倍与3.54倍；对2，4-二硝基苯酚的Langmuir最大吸附量为747 mg/g，与Freundlich模型相比，Langmuir模型能较好地描述2，4-二硝基苯酚在炭样上的吸附行为，表明制备活性炭样品表面吸附位的能量分布较为均一。     

A-O工艺污泥疏水比率与污泥活性的关系

通过A-O工艺对印染废水的降解处理,研究了不同污泥活性下微生物疏水比率和COD去除率的变化规律.结果表明,污泥活性指标ATP浓度与微生物疏水性之间存在一定关系,并对COD去除率产生一定的影响.缺氧污泥的活性指标ATP浓度在0.38～0.77 mg/L范围时,污泥微生物的疏水性最好且疏水比率最高值为84％,COD的去除率最高,为70.01％；好氧污泥的活性指标ATP浓度在0.86～2.17 mg/L范围时,污泥微生物的疏水性最好,疏水比率最高值为75％,COD的去除率最高为96.2％.     

Pesticide residue dynamics in passion fruits: Comparing field trial and modelling results

We evaluated the exposure to pesticides from the consumption of passion fruits and subsequent human health risks by combining several methods: (i) experimental field studies including the determination of pesticide residues in/on passion fruits, (ii) dynamic plant uptake modelling, and (iii) human health risk assessment concepts. Eight commonly used pesticides were applied onto passion fruits cultivated in Colombia. Pesticide concentrations were measured periodically (between application and harvest) in whole fruits and fruit pulp. Measured concentrations were compared with predicted residues calculated with a dynamic and crop-specific pesticide uptake model, namely dynamiCROP. The model accounts for the time between pesticide application and harvest, the time between harvest and consumption, the amount of spray deposition on plant surfaces, uptake processes, dilution due to crop growth, degradation in plant components, and reduction due to food processing (peeling). Measured and modelled residues correspond well (r² = 0.88-0.99), with all predictions falling within the 90% confidence interval of the measured values. A mean error of 43% over all studied pesticides was observed between model estimates and measurements. The fraction of pesticide applied during cultivation that is eventually ingested by humans is on average 10⁻⁴-10⁻⁶, depending on the time period between application and ingestion and the processing step considered. Model calculations and intake fractions via fruit consumption based on experimental data corresponded well for all pesticides with a deviation of less than a factor of 2. Pesticide residues in fruits measured at recommended harvest dates were all below European Maximum Residue Limits (MRLs) and therefore do not indicate any violation of international regulatory thresholds.     

Genotoxicity of chromium in vitro on yeast: Interaction with DNA†

The genotoxicity of chromium chloride was investigated in cells of D₇ strain of Saccharomyces cerevisiae harvested either from logarithmic or stationary growth phase.

A weak induction of mifotic gene conversion and point reverse mutation was obtained when the incubations were performed using phosphate buffer. No genetic effect was observed when the incubations were performed using Tris‐HCl buffer.

The experiments with ⁵¹Cr radiotracer demonstrated that Cr³⁺ ion enters the yeast cells and binds to DNA even if the incubation mixture was performed with Tris HCl buffer. This behaviour could be due to the highest concentration of CrCl₃ that cause some damages to cytoplasmatic membrane.     

Ti/BDD/PbO_2复合电极在化学需氧量测定中的应用

以钛基掺硼金刚石为基体,采用电沉积的方法制备了Ti/BDD/PbO2复合电极,并将其用于化学需氧量（COD）的测定。采用扫描电子显微镜（SEM）和X射线衍射谱图（XRD）表征了电极的微观形貌及结构,采用电化学工作站考察了电极对有机物响应特性。实验结果表明,在1.45 V的低电位条件下,线性范围为0.5～175 mg/L,检测限为0.3 mg/L（S/N=3）。采用Ti/BDD/PbO2复合电极测定法和重铬酸钾标准方法对市政污水、食品废水及印染废水的对比结果表明,2种方法的相对误差小于10%,具有良好的一致性。